Boat build suspension

I'm saddened to report that there will be a (hopefully) short suspension of boat building activities. More materials need to be purchased to properly initiate the construction of the main hull and I cannot justify the expenditure while I am looking for new full time employment.

Daggerboard in case

My daggerboard was always on the thick side so I was a bit worried that with paint the board might stick in the case.  Not to worry, the paint seems to make it more slippery and it slides in and out, horizontally, freely.  I'm sure that in the vertical position it will be fine.  

Daggerboard and rudder mostly done

I've painted the daggerboard and rudder now, with a number of coats of the 2 part Interlux VC performance epoxy.  To apply, I simply used a foam roller and tried to cover with as little paint as possible.  Next time I will to use a foam brush to see if I can get an even smoother application. Of course, the rolling does not finish smooth and does require post wet sanding.  As they are now,  I am still working with 400 grit but they can still be taken a lot farther.  However, at this point they look like they will work out OK so I might leave them like this for the time being and move on to the next step, cutting the form frames for the main hull.

I highly recommend the performance epoxy, it does wet sand very well and I think the product is perfect for parts just like this, that are under the waterline and need to be very smooth.  

I weighed the daggerboard, it's about 16 lbs.